Concrete Calculator for Sonotube
Quickly estimate volume, bag counts, and total material costs for concrete tubes & piers.
Calculation Results
Sonotube Concrete Calculator – Estimate Bags, Volume & Costs
Planning a deck, fence, post footing, or building foundation requires accurate concrete volume estimates to prevent mid-project delays and minimize waste. This Sonotube Concrete Calculator calculates the precise cubic feet, cubic yards, number of pre-mix concrete bags, total weight, and material costs required for your cylindrical pier footings.
How to Calculate Concrete Volume for Sonotubes
Calculating concrete for a Sonotube (cylindrical form) uses the standard volume formula for a cylinder:
Volume = Pi * (Radius)^2 * Depth
Where
- Pi: Approximately 3.14159
- Radius: Half of the tube inner diameter in feet (Diameter in inches divided by 24)
- Depth/Height: Total depth or height of the tube in feet
Standard Sonotube Volume Quick Reference Chart
The table below outlines concrete requirements for standard 4-foot deep Sonotube forms (including a standard 10% waste factor):
| Tube Diameter (in) | Depth (ft) | Volume per Tube (cu ft) | Volume per Tube (cu yd) | 80 lb Bags Needed | 60 lb Bags Needed |
| 6″ | 4 ft | 0.86 cu ft | 0.032 cu yd | 2 bags | 2 bags |
| 8″ | 4 ft | 1.53 cu ft | 0.057 cu yd | 3 bags | 4 bags |
| 10″ | 4 ft | 2.39 cu ft | 0.089 cu yd | 4 bags | 6 bags |
| 12″ | 4 ft | 3.45 cu ft | 0.128 cu yd | 6 bags | 8 bags |
| 14″ | 4 ft | 4.69 cu ft | 0.174 cu yd | 8 bags | 11 bags |
| 16″ | 4 ft | 6.13 cu ft | 0.227 cu yd | 11 bags | 14 bags |
| 18″ | 4 ft | 7.76 cu ft | 0.287 cu yd | 13 bags | 18 bags |
| 24″ | 4 ft | 13.79 cu ft | 0.511 cu yd | 23 bags | 31 bags |
Concrete Bag Yield & Coverage Guide
Different pre-mix concrete bag sizes yield distinct volume outputs:
- 80 lb Bag: Yields approximately 0.60 cubic feet (Requires 45 bags per cubic yard).
- 60 lb Bag: Yields approximately 0.45 cubic feet (Requires 60 bags per cubic yard).
- 40 lb Bag: Yields approximately 0.30 cubic feet (Requires 90 bags per cubic yard).
Pro Tip: Always order 5% to 10% extra concrete to account for soil absorption, tube deflection, uneven hole bottoms, and spillage.
Step-by-Step Sonotube Installation Best Practices
- Dig Below Frost Line: Ensure post holes extend deeper than your local frost depth to prevent frost heave during freezing cycles.
- Set a Solid Base: Pour 4 to 6 inches of crushed gravel at the bottom of the hole for structural drainage before inserting the cardboard tube.
- Plumb and Backfill: Insert the Sonotube, check for vertical level (plumb), and backfill soil around the exterior to hold the form rigid during the pour.
- Consolidate the Mix: Rod or vibrate the concrete as you pour in stages to remove trapped air pockets and internal voids.
- Set Anchor Bolts: Insert rebar or post anchor bolts immediately while the concrete is fresh and plastic.
Frequently Asked Questions (FAQ)
How many 80lb bags of concrete fill a 12-inch Sonotube?
A 12-inch diameter Sonotube requires approximately 1.4 bags of 80 lb concrete per foot of depth. A standard 4-foot deep 12-inch Sonotube requires 6 bags (80 lb each), including a 10% safety margin.
Should I pour concrete directly into a Sonotube or around it?
Concrete is poured directly inside the Sonotube form. Soil or gravel is backfilled around the outside of the tube prior to pouring to secure the form in position.
Do you leave Sonotubes in the ground?
Yes, the cardboard Sonotube form remains in the ground. The outer cardboard skin gradually disintegrates over time without compromising the structural integrity of the cured concrete pier.
Refereance: Sonotube Calculations
- How much will a 20kg bag of concrete cover? - July 30, 2026
- how do I calculate how much concrete I need? How to calculate Concrete volume - July 30, 2026
- Concrete volume calculator vs manual measurement: which is more accurate? - July 28, 2026